Backgammon pip count: how to count, and what to do with the number
In short
Your pip count is the total number of points all your checkers still have to travel to bear off. For each checker, take its point number and add them all up. Both players start at 167. The lower count is ahead in the race, and each roll moves about 8 pips on average, so a lead of 8 is about one roll.
What is a pip?
A pip is one step along the board. Your pip count is the total you would need to roll, in pips, to bear off every checker if nothing was wasted. A checker on your 13-point needs 13 pips, and one on your 1-point needs 1. A checker on the bar needs 25.
Add those up for all your checkers. Whoever has the lower total is ahead in the race. At the start both sides have exactly 167:
| Red’s checkers | Count | Pips |
|---|---|---|
| On 24 | 2 | 48 |
| On 13 | 5 | 65 |
| On 8 | 3 | 24 |
| On 6 | 5 | 30 |
| Total | 15 | 167 |
On our diagrams the point numbers are red’s, so white’s checkers need one more step. To get a white checker’s pips, take 25 minus its point. White’s 19 is 6 pips from off. White’s 1 is 24.
How to count without slowing down
Multiplying every point takes too long at first. A few habits help.
Count in groups of 10. Combine points that add up to a round number. Two checkers on 6 and one on 8 add to 20. Five on 6 is 30 and five on 13 is 65. After a while these become chunks you recognise.
Keep a running difference. You don’t need the total, you need the gap. If you both have the same stack on the same point, skip it. In the worked example below, red’s four on 6 match white’s four on 19, so you can skip both.
Update after each turn. Once you know the count at a moment in the game, you can keep it going. Take each roll off the count of the player who rolled it: if you roll 5-3, your count drops by 8. Doubles count four times, so 6-6 takes off 24. If one of your checkers is hit, add back what it loses: 25 minus the point it stood on. Starting from 167 this needs nothing but small sums.
Use the start as a test. When you learn, count the opening position a few times and check that you reach 167. It trains your eye for the usual stacks.
A worked example
Red: three on 8 is 24, four on 6 is 24, three on 5 is 15, three on 4 is 12, two on 3 is 6. Total 81.
White, using 25 minus the point: three on 18 is 21, four on 19 is 24, three on 20 is 15, three on 21 is 12, two on 22 is 6. Total 78.
White leads by 3, but it is red’s roll. Being on roll is worth about 4 pips, half of an average roll, so this race is about level.
Counting a position with contact
Races are easy to count because nothing changes but the dice. In the middle of a game you also have to count the bar.
Red first: the checker on the bar is 25, the blot on 20 is 20, four on 13 are 52, three on 8 are 24, four on 6 are 24 and two on 5 are 10. That makes 155.
White, with 25 minus each point: two on 1 are 48, three on 12 are 39, one on 16 is 9, three on 17 are 24, four on 19 are 24 and two on 21 are 8. That makes 152.
So white leads by only 3 pips, even though red is on the bar. Red’s real problem is time, not distance: the checker on the bar must enter before anything else moves, and the blot on 20 is still in white’s home board. A count tells you the race. It does not tell you who has the better position, so read it together with the board.
What does a lead mean?
The average roll is 8 1/6 pips, about 8.17, once you count doubles at four times their face value; the odds page shows where that comes from. It gives you an easy way to turn pips into time: 8 pips is about one roll.
| Lead | In rolls | What it means in a long race |
|---|---|---|
| 0 to 4 | Under half a roll | Whoever is on roll is about even or slightly ahead |
| 8 | About one roll | A real lead in a race of 100 pips |
| 16 | About two rolls | A strong lead |
| 24 or more | Three rolls | The race is close to decided unless a hit changes it |
A percentage is more useful than a raw number, because a lead counts for more when fewer pips are left. A lead of 8 out of 100 is 8%. A lead of 8 out of 40 is 20%, which is usually decisive. In Turkish tavla, with no cube, these numbers simply tell you how good your race is.
What should you do with the number?
The count decides your plan. Here are some common situations.
You are ahead. Break contact. Move back checkers past theirs, and don’t stay on an anchor with nothing to gain. You want a simple race, and you want to avoid getting hit.
You are behind. Keep contact. Hold your anchor and your midpoint. You need a shot, because a straight race will not rescue you. A deficit of 20 pips or more, two and a half rolls, is too much to make up by running. The strategy guide explains how to play this kind of holding game.
A hit changes the count. Before you hit late in the game, check what the hit gains in pips as well as in time. A hit deep in your own board costs your opponent little in the race, a hit far up the board a lot; hitting and the bar has the numbers.
Gammon. Use the count to check whether you can save the gammon, called mars in tavla. Count the pips you need to bring every checker home, add one bear-off, and compare that with the rolls you have left; the gammon page works through an example.
Why the same count can be a different race
Pips ignore waste. Any time you bear off from a low point with a big number, you throw pips away, and checkers piled on low points waste the most.
Both of these have a count of 6. A single checker on the 6-point comes off in one roll 27 times in 36. Any non-double that adds up to 6 or more will do it, and so will every double except hep yek (1-1). Six checkers on the 1-point always take at least two rolls, because even a double removes only four.
So when you compare two close counts, look at how they are spread. Stacks on low points and gaps on your home board cost you pips the count doesn’t show. Crossing checkers into your home board efficiently, and filling the 6, 5 and 4 before anything lower, keeps the waste down.
How to practise with the count on screen
tavla.gg shows both pip counts during a game, next to the players’ names, as Pips left. Use them as an answer key, not as a crutch.
- Cover the numbers with your thumb, or just look away from them, and count the position yourself.
- Compare. If you were off, find the stack you got wrong. It is usually the midpoint or a checker on the bar.
- Repeat at three moments in the same game: after the opening, once your back checkers have moved, and before you bear off.
After a few games you will be counting a race faster than you can read the numbers off the screen, and that is the skill you need at a real board.
Try it on the board
No sign-up. Play the computer or a friend right now.
Frequently asked questions
What is the pip count at the start of a game?
It is 167 for each player. That is two checkers on 24 (48), five on 13 (65), three on 8 (24) and five on 6 (30). You can use this number as a check when you learn to count during a game.
How do I count my opponent's pips?
From their side, their points are numbered the same way as yours from your side. With our red numbering, each white checker counts as 25 minus the point it stands on. A white checker on 19 is 6 pips from bearing off, and one on 12 is 13.
Does a checker on the bar count as 25?
Yes. A checker on the bar still has to enter in the opponent's home board and travel the whole way, so it counts 25 pips. Add 25 for each of your checkers on the bar, and nothing for checkers already borne off.
Am I allowed to count pips during a game in tavla?
Yes. You count in your head, and it is entirely normal in tournament backgammon. There is no rule against it anywhere we know of. In a fast casual game, just do it quickly.
What is a big lead in a race?
Use percentages, because a 10-pip lead means more when both sides are low. As a rough guide, 8% of your count or more is a solid lead. At 100 pips that is 8. At 50 pips, 4 pips is already a real advantage.
Who is really ahead if we have equal counts?
The player on roll, because they get to move first in a race of equal length. After that, look at position: gaps on your low points and many checkers on the 1-point cost you more than the count shows.
What does the 8-9-12 rule mean?
It is a guide for races with the doubling cube, used in international backgammon. Double with a lead of 8%, redouble with 9%, and pass if you trail by more than 12%. Turkish tavla has no cube, so you only need it for that game if you turn the cube on in the Rules step.
Should I run with my last checker if I am ahead by only a few pips?
Usually yes, once you are ahead and it is your roll, because a small lead with the dice in your hand is a real lead in a race. If you are behind, the opposite is true: you want contact, and you keep your anchor as long as you can.
Do I need to count every turn?
No. Count at the turning points: before you decide to run or hold, before you break an anchor, when the last contact is about to go, and when a gammon is in the balance. In between, keep the count running by taking each roll off the total of the player who rolled it.
Why learn to count if tavla.gg shows the pip count?
Because a real board shows you nothing, and because counting trains you to see a race at a glance. Use the numbers on the screen as a check: count first, then look, and see how far off you were.